[0.64.2] Crash placing Wall

[PnzrNorm]

Crash occurred while placing Basic Wall segments.

Placed 2 connected segments, decided I didn't like it so I hit Esc to cancel.
Placed 1 segment and began planning the 2nd segment when it crashed.

There was nothing else on-screen at the time except the environment.

[PnzrNorm]

2nd crash occurred after placing 3 sequential Basic Wall segments.

This was the first action I attempted as soon as the game fully loaded.

[PnzrNorm]

3rd crash occurred.
I think I found a reproducible method to cause this issue.

Steps to Reproduce:

• Open Build Menu, Select Basic Wall
  Place first segment of Basic Wall
  Click to place the second segment of Basic Wall; Note that this does not actually need to place the wall segement (i.e. Ground not level enough notification)
  Wait approximately ~3 seconds and the crash will occur

Haven't been able to find a workaround to this yet.
Currently researching concrete walls to test this again.

UPDATE: Issue does not occur with Basic Gates

[Set]

The game crash when you build turrets too

[PnzrNorm]

Encountering a similar issue trying to build Defensive Walls.
Only this time, it crashes upon attempting to begin the 2nd sequence of segments.

[PnzrNorm]

Scratch that last comment.
Just encountered a 2nd crash while attempting to place Defensive Walls.
This time it was a longer, straight sequence of ~9 segments (didn't get an exact count due to some being off-screen).

[Set]

Crashed when placing a wall ramp

[AmbiguousMonk]

This crash is occurring regularly for me as well. I can sometimes get to placing the third set of basic walls, but the game always crashes at some point during the wall placement. Despite this crash being reported several times already, I wanted to post my crash report just to provide additional information about the issue.

[paladin]

Ok so continually when trying to build walls the game crashes UNsure about why but when you drag the wall it goes about 3-5 walls then crashes..

[PnzrNorm]

Likely its the same crash as this thread:
Crash Upon Placing Wall

[PnzrNorm]

Linking this thread since it has the same cause:

Crash Upon Placing Wall

[Eiron]

Mine happened when I was trying to place a gate. I fired up the game again, placed the gate successfully, but the game immediately crashed before I could select wall segments to go with it. I tried to upload my save, but I got a message saying, "Sorry, the board attachment quota has been reached."

Edit: The third try let me build a gate and several wall segments, and crashed upon trying to place a ramp.

[PnzrNorm]

I may have found a workaround for this issue.

So long as you spend less than 3-5 seconds in Build Mode and place no more than 3 segments per Build Mode, you should be find.
Or I should say, this has worked for me 4 times sequentially without a single crash.